Diversification of hand tool wood clamp and tips to use

Variety of hand tools online would never be an issue for any worker, as the only thing is to know the right tool for the correct situation. Before having any tool, it is better to understand its usage, precautions, the damage it could cause, etc. some clamps are versatile, no one could cover everything with a single clamp. Their workings depend on desired clamping pressure, workpiece size, and joint angle. Always try to pick the clamp according to the job and requirement. Many companies have hand tool for sale in affordable prices and excellent quality material;

Here is the list of some most popular clamp used by the professionals and daily requirements.

  • Trigger-activated bar clamp
  • Pipe clamp
  • Parallel-jaw clamp
  • Corner Clamp
  • C-clamp or carriage clamp
  • Wood screw clamp
  • Strap Clamp
  • Spring Clamp

Some indispensable points for getting best from your clamp

Handy tip #1: apply the right amount of pressure evenly

This is a general thumb rule to use the clamp, always apply just enough pressure to hold workpiece accurately along with the entire glued joint surface. You may wish to squeeze out some glue but make sure it glue should not be squeezed out entirely from the joints. Less or more equal squeeze out amongst the joint line is essential.

Handy tip #2: alter the place of clamps

When edge-gluing boards for a larger panel or table tops. Adjust the clamps pipes and bars over the bottom and top surfaces of the glue-up. This help in countering laminated boards from twisting as uneven pulling forces on one clamp would counteract the unequal pulling power of either side of the clamp. Try to start with one clamp on the underside of the glue-up, after that place the next clamp on it.

Handy tip #3: prevent dent and stains with low-cost barriers

While using the clamp on a metal jaw without protective plastic pads, try to fix the piece of waxed paper between the workpiece and clamps. It prevents clamp from sticking to the surface or nasty wood because of glue, and it could also cause glue’s moisture, metal jaws come in contact and wood’s tannin. If marring and denting could occur, try to put a scrap of softwood between the wood and jaws surfaces.

Handy tip #4: spreading glue correctly

Before starting anything, make sure the paste has spread over the entire surface and joints. Using a small glue roller or brush would work fine. Please never try to spread glue by using fingers as it may be risky and get glue all over the surface of the workpieces, and it also gives a blotchy stained finish.

Handy tip #5: flat surface would be perfect

Assemble table should be flat; otherwise, it will throw the clamp out of square despite the best efforts. It may introduce racking and twisting, which will be a headache to fix. This is the reason most of the worker tries to work on dead-fla, cast iron top on the table surface.

Leave a Reply

Your email address will not be published. Required fields are marked *